ZIEHL-ABEGG ZETADYN 3C, Оригинальная инструкция по эксплуатации

Страница: 149 / 204

13.6 Operating conditions of the inverter
The frequency inverter software divides the operating curve into various sections. Each of
these sections is assigned a status number that refers to a de
fi
ned service condition.
If an error occurs, the status number is stored with the error number in ther error list.
Furthermore, the operating conditions are displayed with the status number and in plain test in the
Info/Page02
menu.
status Condition of the inverter status Condition of the inverter
10 Checking of voltage supply 430
Constant running at speed V3(time-dependent,
V1 is not activated)
21 Check software version 431
Round down the acceleration to V3 (distance-de-
pendent)
22 Parameter transmission 432 Linear acceleration to V3 (distance-dependent)
30 Check absolute value encoder 433 Constant travel with V3 (distance-dependent)
41
42
Check input BC
41: Power feedback unit
42: Brake chopper or brake resistor
435 Deceleration with safety ramp
50 Adjust current transformer 440 distance dependent travel with DCP4
70 Check temperature power unit 480 Retract to standstill
100 Device off 490 fast stop
105 Power feedback unit on standby 500 Keep motor at speed 0 (T4)
110 Machine ready 510 Wait until motor brakes are closed (T5)
200 Start-up check 515 Brake gets additional current feed for 1s
210 ... 223 Check absolute value encoder 520
Switch off current to motor (T5b)
300 Wait until motor contactors switched on (T0) 530 Wait until motor contactors switched off (T6)
305 Checking the motor phases 535
Travel interrupted due to interruption of the con-
troller enable RF
310
311
Build-up of magnetic
fi
eld in the motor (T1)
536
Travel interrupted due to interruption of the con-
tactor monitor COx
320 Wait until motor brakes have opened (T2) 540 Wait for standstill
330 Accelerate motor to speed V_T3 (T3) 550 Checking the input BR after travel
fi
nished
340 Start up 560 End of travel
400 Accelerate to speed Vx 900
Delay of automatic acknowledgement after reme-
dying the cause of the fault (2 s)
402 Constant running at speed Vx 950 Parameter change
404 Delay from speed Vx 982 Motor type changed
410 Constant running at speed V1 988 Wait for reset
420 Constant running at speed V2 990 Fault input BC
421
Round down the acceleration to V2 (distance-de-
pendent)
991 No absolute value encoder detected
422 Linear acceleration to V2 (distance-dependent) 992 Temperature of the power section missing
423 Constant travel with V2 (distance-dependent) 997 Frequency converter is in stand-by mode
424
Rounding up and linear delay from V2 (distance-
dependent)
998 Wait until frequency converter is switched off
425
Rounding down of the delay from V2 (distance-
dependent)
4xx 2xx
5xx
3xx
Travel curve with related status numbers
Original operating instructions
ZETADYN 3C
Error diagnosis
R-TBA08_03-GB 1619 Part.-No. 00163322-GB
149/204