Weq CTW900, Руководство пользователя

Страница: 55 / 144

Start-up
CTW900 | 55
Seq. Action/Result Indication on the display Seq. Action/Result Indication on the display
1
- Monitoring Mode
- Press
“Menu” (left soft
key).
8
- Change the content of
P0201 (
Language ) and
P0202 ( Speed Feedback
Selection ) if necessary.
2
- The group “ 00 ALL
PARAMETERS ” is
selected.
- Press
“  ” until selecting
the group “02 ORIENTED
START-UP” .
9
- Set the value of P0296
(
Line Rated Voltage ) and
P0297 ( Field Control
Loop ) according to the
line and application.
3
- The group “02
ORIENTED START-UP”
is then selected.
- Press
“Select” .
10
- Choose the Control
Mode in P0299 and the
Armature Rated Voltage
in P0400.
4
- The “Oriented Start-up”
is already selected.
- Press
“Select” .
11
- Configure the Armature
Rated Current in P0401
and the Motor Rated
Speed in P0402.
5
- The content of “P0317
= [000] No” is displayed.
- Press “

” .
12
- Set the value of the
Field Rated Current
(P0404) and the Number
of Encoder Pulses
(P0405) according to the
application.
Note: Parameter P0405
will only be displayed if
the accessory board
ENC-01 or ENC-02 is
connected to the
converter.
6
- The content of the
parameter changes to
“P0317 = [001] Yes” .
- Press “Save” .
13
- Change, if necessary,
the value of the
Tacho
Voltage for 1000 rpm
(P0406) and of the
Armature Resistance
(P0409).
- In order to finish the
Oriented Start-up routine,
press
“Reset” (left soft
key) or
.
7
- At this moment, the
Oriented Start-up routine
starts and the “Config”
status is displayed on the
upper left corner of the
keypad (HMI).
- The parameter
“Maximum Speed” is
already selected.
- If necessary, change it to
another value, according
to the application, by
pressing
“Selec.”,“

” or
“

” and then “Save” .
- Also set the value of the
Field Minimum Current
(P0177) according to the
motor.
14
- After some seconds,
the display returns to the
Monitoring Mode.
Figure 6.2 – Sequence of the Oriented Start-up routine