Trox Technik FKRS-EU, Инструкция по установке и эксплуатации

Страница: 103 / 176

Fig. 86: Dry mortarless installation with fire batt into a half-timbered construction
1 FKRS-EU
2.4 Fire batt with ablative coating
3.5 Half-timbered construction, cladding on both
sides
4.1 Solid ceiling slab / solid floor
6.8 Infill (cavities completely filled with mineral wool
≥
1000 °C,
≥
50 kg/m³, or bricks, aerated con-
crete, lightweight concrete, reinforced concrete
or clay)
6.10 Ablative coating around the perimeter,
d = at least 2.5 mm
6.19 Mineral wool > 1000 °C, > 80 kg/m³,
thickness = 20 mm, panel material around the
perimeter, leave out the actuator and release
mechanism; inspection openings must remain
accessible
6.20 Sleeve (can be ordered separately)
6.24 Elastomeric foam (flame-resistant, non-drip-
ping)
The following applies in Germany: For notes
on the use of elastomeric foams, see Ä 7 .
7.9 Half-timbered construction
7.11 Trim panels, fire-resistant, double layer, stag-
gered joints
7.13 Cladding
7.14 Reinforcing board of the same material as the
wall
* 6.19, 6.20 or 6.24 as an alternative
**
Installation near the floor analogous to
– See table
Ä
103
Half-timbered wall
NW
[mm]
Fire resistance properties
to
Coating Detail
Installation side
A
Operating side
B
100 – 200 EI 90 S – – ,
100 – 315 EI 90 S – x
,
100 – 200 EI 120 S – x ,
100 – 315 EI 120 S x x ,
100 – 315 EI 30 S – – ,
Installation
Lightweight partition walls with timber support ... > Dry mortarless installation with fire batt
Fire damper Type FKRS-EU 103