Suzuki Liana RH413, Руководство по обслуживанию

Страница: 209 / 1302

Engine Mechanical: 1D-4
If valve lash is out of specification, record valve lash and
adjust it to specification by replacing shim.
Valve clearance specification
Replacement of Shim
1) Close the valve whose shim (2) is to be replaced by
turning crankshaft, then turn tappet (3) till its cut
section (1) faces inside as shown in the figure.
2) Lift down the valve by turning crankshaft to 360
°
3) Hold tappet at that position using special tool as
follows.
a) Remove its housing bolts.
b) Check housing No. and select special tool
corresponding to housing No., referring to
“Special tool selection table”.
Special tool selection table
c) Hold down the tappet so as not to contact the
shim by installing special tool on camshaft
housing with housing bolt (1) tighten housing
bolts to specified torque.
Special tool
(A): 09916–67021
Tightening torque
Camshaft housing bolt (a): 8 N·m (0.8 kgf-m,
6.0 lb-ft) for tightening of special tool
When cold (Coolant
temperature is 15 –
25
°
C (59 – 77
°
F))
When hot (Coolant
temperature is 60 –
68
°
C (140 – 154
°
F))
Intake 0.18 – 0.22 mm
(0.007 – 0.009 in.)
0.21 – 0.27 mm
(0.008 – 0.011 in.)
Exhaust 0.28 – 0.32 mm
(0.011 – 0.013 in.)
0.30 – 0.36 mm
(0.012 – 0.014 in.)
I2RH0B140010-01
No. on camshaft
housing
Embossed mark on special
tool
I2 IN2
I3, I4, I5 IN345
E2 EX2
E2, E4, E5 EX345
A: I: Intake side or E: Exhaust side
B: Position from timing chain side
C: Pointing to timing chain side
I2RH0B140006-01
I2RH0B140011-01