Suzuki Liana RH413, Руководство по обслуживанию

Страница: 152 / 1302

1A-101 Engine General Information and Diagnosis:
Wiring Diagram
DTC Detecting Condition and Possible Cause
DTC Confirmation Procedure
1) Turn ignition switch OFF.
2) Clear DTC with ignition switch ON, crank engine and run it at idle for 3 min.
3) Check pending DTC and DTC.
DTC Troubleshooting
C41 (31P) G04 (24P) G03 (17P)
1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 16 17 18 19 20 21
22 23 24 25 26 28 27 29 30 31
5 6 1 2 3 4 5 6 7
11 12 9 10 11 13 12 14 15 16
16 17
1 2
7 8
13 14
3 4
9 10
15 17 18
8
19 20 21 22 23 24
BLK/YEL
3
2
1
C41-30
ECM
I2RH0B110068-01
1. Ignition switch
2. Transmission range switch (A/T)
3. Starter motor
DTC detecting condition Possible cause
• Low voltage at terminal “C41-30” when cranking engine.
or
• High voltage at terminal “C41-30” after starting engine.
*2 driving cycle detection logic, continuous monitoring • “BLK/YEL” circuit open
• ECM malfunction
Step Action Yes No
1 Was “Engine and Emission Control System Check”
performed? Go to Step 2. Go to “Engine and
Emission Control
System Check”.
2 Terminal voltage check
1) Disconnect connectors from ECM with ignition switch
turned OFF.
2) Remove ECM from vehicle body and then connect
connectors to ECM.
3) Check for voltage at terminal “C41-30” of ECM
connector connected, under the following condition.
Terminal voltage
While engine cranking: 6 – 10 V
After starting engine: 0 V
Is voltage as specified?
Poor “C41-30”
connection or
intermittent trouble.
Check for intermittent
referring to “Intermittent
and Poor Connection
Inspection in Section
00”.
If wire and connections
are OK, substitute a
known-good ECM and
recheck. “BLK/YEL” circuit open.