Suzuki Liana RH413, Руководство по обслуживанию

Страница: 1024 / 1302

8B-99 Air Bag System:
Installation
For installation, reverse removal procedure, nothing
following points.
• Check none of the following conditions exists.
– Bend, scratch, deformity in vehicle body mounted
on SDM
– Foreign matters or rusts on mating surface of
vehicle body mounted on SDM
• Ensure that arrow (4) on the SDM (3) is pointing
toward the front of the vehicle.
• Tighten SDM bolts (1) to specified torque.
Tightening torque
SDM mounting bolt ((a)): 11 N·m (1.1 kgf-m, 8.0
lb-ft)
• Connect SDM connector (2) to SDM (3) securely.
• Enable air bag system. Refer to “Enabling Air Bag
System”.
SDM Inspection
S3RH0A8206004
WARNING
!
During service procedures, be very careful
when handling a Sensing and Diagnostic
Module (SDM).
Be sure to read “Precautions on Service and
Diagnosis of Air Bag System” before starting
to work and observe every precaution during
work. Neglecting them may result in personal
injury or inactivation of the air bag system
when necessary.
CAUTION
!
• Do not connect a tester whatever type it
may be.
• Never repair or disassemble SDM (3).
• If SDM has been dropped, or if there are
cracks, dents or other defects in the case
or plate, replace it with a new one.
1) Remove the SDM referring to “SDM Removal and
Installation”.
2) Check SDM as follows.
If any faulty condition is found in the following
checks, replace.
• Check SDM (1) for dents, cracks or deformation.
• Check SDM connector (2) for damage, cracks or lock
mechanism.
• Check SDM terminal for bent, corrosion or rust.
2
3
4
1, (a)
1, (a)
FORWARD
I2RH01820058-01
1
2
I2RH01820057-01