Suzuki Liana RH413, Руководство по обслуживанию

Страница: 538 / 1302

4E-36 ABS:
Installation
1) Install hydraulic unit / control module assembly by reversing removal procedure.
Tightening torque
Brake pipe flare nut (a): 16 N·m (1.6 kgf-m, 11.5 lb-ft)
ABS hydraulic unit / control module assembly bolt (b): 9 N·m (0.9 kgf-m, 6.5 lb-ft)
ABS hydraulic unit / control module assembly bracket bolt (c): 23 N·m (2.3 kgf-m, 17.0 lb-ft)
2) Bleed air from brake system referring to “Air Bleeding of Brake System in Section 4A”.
3) Check each installed part for fluid leakage and perform “ABS Hydraulic Unit Operation Check”.
NOTE
For new ABS hydraulic unit / control module assembly, if “ABS Hydraulic Unit Operation Check”
procedure has not been performed, ABS warning lamp may flash when ignition switch is turned ON
position.
Accordingly preform “ABS Hydraulic Unit Operation Check” to stop flashing of ABS warning lamp.
(b)
(a)
(b)
(c)
(a)
(c)
I4RH01450017-01