Suzuki Liana RH413, Руководство по обслуживанию

Страница: 268 / 1302

1E-5 Engine Lubrication System:
3) After fitting oil pan (3) to cylinder block, run in
securing bolts and start tightening at the center:
move wrench outward, tightening one bolt at a time.
Tighten bolts and nuts to specified torque.
Tightening torque
Oil pan bolts and nut (a): 11 N·m (1.1 kgf-m, 8.0
lb-ft)
4) Install new gasket and drain plug to oil pan.
Tighten drain plug to specified torque.
Tightening torque
Oil pan drain plug bolt (b): 50 N·m (5.0 kgf-m,
36.5 lb-ft)
5) For 4WD vehicle, install clutch housing (torque
converter housing for A/T vehicle) lower plate (1).
6) For 2WD vehicle, install lower stiffener referring to
“Manual Transaxle Unit Components in Section 5B”.
7) For 4WD vehicle, install transfer referring to
“Transfer Dismounting and Remounting in Section
3C”.
8) Install exhaust manifold stiffener and exhaust No.1
pipe referring to “Exhaust Pipe Removal and
Installation in Section 1K”.
9) Install oil level gauge.
10) Refill engine with engine oil, referring to “Engine Oil
and Filter Change in Section 0B”.
11) Verify that there is no engine oil leakage and exhaust
gas leakage at each connection.
Oil Pan and Oil Pump Strainer Cleaning
S3RH0A1506003
• Clean mating surface of oil pan and cylinder block.
Remove oil, old sealant, and dust from sealing
surface.
• Clean oil pump strainer screen (1).
Oil Pump Components
S3RH0A1506004
I2RH0B150013-01
1
I2RH0B150009-01
1. Rotor plate
2. Outer rotor
3. Inner rotor
4. Timing chain cover
: For detail of timing chain cover components, refer to “Timing
Chain Cover Components in Section 1D”.
5. Pin
6. Relief valve
7. Spring
8. Retainer
9. Circlip
10. Oil pump mounting bolt
: Tightening torque
: Do not reuse.
:
Apply thin coat of engine oil to sliding surface of each parts.
I2RH0B150015-01
I2RH0B150016-01
I3RH0A150003-01