Suzuki Liana RH413, Руководство по обслуживанию

Страница: 259 / 1302

Engine Mechanical: 1D-54
• If necessary, regrind crankshaft journal and select
undersize bearing to use with it as follows.
a. Regrind journal to the following finished diameter.
Finished journal diameter
For M13 engine: 44.7320 – 44.7500 mm (1.7611
– 1.7618 in.)
For M16 engine: 51.7320 – 51.7500 mm (2.0367
– 2.0374 in.)
b. Using micrometer, measure reground journal
diameter.
Measurement should be taken in two directions
perpendicular to each other in order to check for
out-of-round.
c. Using journal diameter measured above and
alphabets stamped on cylinder block, select an
undersize bearing by referring to the following
table.
Check bearing clearance with newly selected
undersize bearing.
New standard undersize crankshaft main
bearing specification
[For M13 engine]
[For M16 engine]
Bearing Cap Bolt
Measure each thread diameter bearing cap bolts (1) at
“A” and “B” by using a micrometer (2).
Calculate difference in diameters (“A” – “B”).
If it exceeds limit, replace with new one.
Bearing cap No.1 bolt diameter measurement points
“a”: 60 mm (2.36 in.)
“b”: 90 mm (3.54 in.)
Bearing cap No.1 bolt diameter difference
Limit: (“A” – “B”): 0.2 mm (0.008 in.)
Sensor Plate Inspection
S3RH0A1406049
Check sensor plate for crack damage.
If malcondition is found, replace it.
Measured journal diameter
44.7320 –
44.7379 mm
(1.7611 –
1.7613 in.)
44.7380 –
44.7439 mm
(1.7614 –
1.7615 in.)
44.7440 –
44.7500
mm
(1.7616 –
1.7618 in.)
Alphabet
s
stamped
on
cylinder
block
A Red and
Brown
Red and
Purple
Red and
Pink
B Red and
Green
Red and
Brown
Red and
Purple
C Red and
Black
Red and
Green
Red and
Brown
Undersize bearing to be installed
I2RH0B140144-01
Measured journal diameter
51.7320 –
51.7379 mm
(2.0367 –
2.0369 in.)
51.7380 –
51.7439 mm
(2.0370 –
2.0371 in.)
51.7440 –
51.7500 mm
(2.0372 –
2.0374 in.)
Alphabet
s
stamped
on
cylinder
block
A Red and
Green
Red and
Brown
Red and
Purple
B Red and
Black
Red and
Green
Red and
Brown
C Red only Red and
Black
Red and
Green
Undersize bearing to be installed
“A”
“a”
“b”
“B”
1
1
2
I2RH0B140145-01
I3RH0A140013-01