Suzuki Liana RH413, Руководство по обслуживанию

Страница: 373 / 1302

Rear Suspension: 2C-9
2) Install coil spring lower seat (2) and compressing coil
spring, mate large-diameter spring end with stepped
part of lower seat as shown.
3) Install bump stopper onto strut rod.
4) Instal dust cover onto bump stopper.
5) Fit coil spring (rubber) seat (2) in coil spring upper
seat (1), making sure that their depth matches all
around. No part of rubber seat should stick out
higher than upper seat.
6) Pull strut rod as far up as possible and use care not
to allow it to retract into strut.
7) With “OUT” mark (3) on spring upper seat (1) and
the center of strut bracket (2) aligned, place upper
spring seat together with spring (rubber) seat on coil
spring.
8) Put strut support (2) on spring upper seat (3).
Tighten strut nut (1) to specified torque.
Tightening torque
Strut upper nut (a): 70 N·m (7.0 kgf-m, 50.5 lb-ft)
9) Loosen and remove special tool (A) installed in Step
1) from compressing coil spring. While loosening
special tool, recheck that stepped part of spring seat
and spring end are in place to each other as
described in foregoing Step 2).
Also, check to make sure that “OUT” mark on upper
seat is matched with the center of strut bracket as
described in Step 7).
1. Strut lower seat
I2RH01230020-01
I2RH01230021-01
I2RH01230022-01
I2RH01230023-01