Suzuki Liana RH413, Руководство по обслуживанию

Страница: 486 / 1302

4B-2 Front Brakes:
Front Disc Brake Pad On-Vehicle Inspection
S3RH0A4206002
Inspect pad linings (1) periodically according to
maintenance schedule whenever wheels are removed
(for tire rotation or other reason). Take a look through
each end (or hole) of caliper and check lining thickness
of outside and inside pads.
If lining is worn and its thickness (“a” in figure) is less
than limit, all pads must be replaced at the same time.
Front brake pad thickness “a” (lining thickness)
Standard: 10 mm (0.40 in.)
Limit: 2 mm (0.08 in.)
Front Disc Brake Pad Removal and Installation
S3RH0A4206003
Removal
1) Loosen wheel nuts and with vehicle lifted up, remove
wheels.
2) Remove caliper pin bolts (1).
3) Remove caliper (1) from caliper carrier (2).
NOTE
Hang removed caliper (1) with a wire hook (4)
or the like so as to prevent brake hose from
bending and twisting excessively or being
pulled.
Don’t operate brake pedal with brake pads
removed.
4) Remove brake pads (3).
Installation
1) Before installing brake pad shim, apply small amount
of grease (included in spare parts) to mating
surfaces of brake pad and pad shim.
2) Set brake pad springs (1) and shim (2) and install
brake pads (3).
NOTE
For right side brake, install pad with wear
indicator (4) to vehicle center side.
3) Install caliper and tighten caliper pin bolts (1) to
specified torque.
Tightening torque
Caliper pin bolt (a): 22 N·m (2.2 kgf-m, 16.0 lb-ft)
for NISSIN made caliper
Caliper pin bolt (a): 35 N·m (3.5 kgf-m, 25.5 lb-ft)
for other than NISSIN made caliper
I2RH01420001-01
1
I2RH01420003-01
I2RH01420004-01
I2RH01420006-01
1, (a)
I2RH01420007-01