Suzuki Liana RH413, Руководство по обслуживанию

Страница: 424 / 1302

3B-11 Differential:
5) To measure bevel gear backlash, set dial gauge at
right angle to bevel gear tooth, fix drive bevel pinion,
tighten both retainers and read dial gauge while
moving bevel gear.
NOTE
• Be sure to apply measuring tip of dial
gauge at right angles to convex side of
tooth.
• As a practical measure the following would
be recommended to obtain specified
backlash and side bearing preload at the
same time.
– Obtain specified backlash by turning
both retainers inward lightly.
– Tighten both retainers further by one
notch at a time.
• Measure at least 4 points on drive bevel
gear periphery.
Special tool
(C): 09900-20606
: 09923-58520
: 09900-20701
Drive bevel gear backlash
Standard: 0.1 – 0.2 mm (0.004 – 0.008 in.)
6) With bevel gear installed, measure rotational torque
while turning bevel pinion about 50 rpm by using
special tool.
Special tool
(E): 09922-75222
Differential side bearing preload
(Measured bevel pinion bearing preload) + (3 – 5
kg-cm (2.6 – 4.3 lb-in.))
Rotational force with special tool
(Measured bevel pinion rotational force) + (0.6 –
1 kg (1.3 – 2.2 lb))
I3RH01322039-01
1. Spring balance (1 – 5 or 1 – 10 kg range)
2. Flange bolt
I3RH01322040-01