Suzuki Liana RH413, Руководство по обслуживанию

Страница: 1041 / 1302

Air Bag System: 8B-116
• Air bag (inflator) module and seat belt pretensioner
immediately after deployment / activation is very hot.
Wait for 30 minutes to cool it off before handling it.
• Never apply water, oil, etc. to deployed air bag
(inflator) module and activated seat belt pretensioner
to cool it off and be careful so that water, oil etc. does
not get on deployed air bag (inflator) module and
activated seat belt pretensioner.
• After air bag (inflator) module has been deployed,
surface of air bag may contain a powdery residue.
This powder consists primarily of cornstarch (used to
lubricate air bag (inflator) module as it inflates) and
by-products of chemical reaction. As with many
service procedures, you should wear gloves and
safety glasses.
• When disposing of deployed air bag (inflator) module
and activated seat belt pretensioner, be sure to seal it
in a vinyl bag.
• When air bag (inflator) module and seat belt
pretensioner have been deployed / activated inside of
vehicle which is going to be scrapped, leave them as
installed to vehicle.
• Be sure to wash your hands with mild soap and water
after handling it.
Specifications
Tightening Torque Specifications
S3RH0A8207001
Reference:
For the tightening torque of fastener not specified in this section, refer to “Fasteners Information in Section 0A”.
Special Tools and Equipment
Use of Special Tools
S3RH0A8208001
WARNING
!
To avoid deployment when troubleshooting
the air bag system, do not use electrical test
equipment such as a battery powered or AC
powered voltmeter, ohmmeter, etc., or any
type of electrical equipment other than that
specified in this manual. Do not use a non-
powered probe type tester.
Instructions in this manual must be followed
carefully, otherwise personal injury may
result.
You should be familiar with the tools listed under the
heading SPECIAL TOOLS. You should be able to
measure voltage and resistance. You should be familiar
with proper use of a scan tool such as Air Bag Driver /
Passenger Load Tool, Connector Test Adapter Kit and
the Digital Multimeter.
Special tool
(A): 09932-76010
IYSQ01820095-01
IYSQ01820088-01
Fastening part
Tightening torque
Note
N
⋅
m kgf-m lb-ft
SDM mounting bolt 11 1.1 8.0
)
Side sensor bolt 9 0.9 6.5
)
Driver air bag (inflator) module mounting bolt 9 0.9 6.5
)
Passenger air bag (inflator) module attaching
bolt
23 2.3 16.5
)
Side air bag (inflator) module mounting bolt 23 2.3 16.5
)