Suzuki Liana RH413, Руководство по обслуживанию

Страница: 378 / 1302

2C-14 Rear Suspension:
Rear Suspension Frame Removal and
Installation (2WD Model)
S3RH0A2306015
Removal
1) Hoist vehicle and remove rear wheels.
2) Remove muffler referring to “Exhaust Manifold
Removal and Installation in Section 1K”.
WARNING
!
To avoid the danger of being burned, do not
touch the exhaust system when the system is
hot. Any service on the exhaust system
should be performed when the system has
cooled down.
3) Remove stabilizer bar. Refer to “Rear Stabilizer Bar
and/or Bushings Removal and Installation”.
4) Detach LSPV spring end from left side control rod
(No.2) (if equipped with LSPV).
5) To facilitate toe adjustment after reinstallation, put
match marks (4) on washer (3) and on suspension
frame (2).
6) Remove control rod No.2 (right and left).
7) Remove control rod No.1 (right and left).
8) Remove suspension frame bolts (2) and suspension
frame (1).
9) Remove suspension frame bushings (1) by using a
pipe (2) whose outer diameter “a” is 37 mm (1.46 in.)
and inner diameter “b” is 27 mm (1.06 in.) or more,
an appropriate support (3) and hydraulic press (4).
Installation
1) Press-fit suspension frame bushings (1) by using
special tools (A), (B) and hydraulic press (2).
Special tool
(A): 09951-16080
(B): 09940-53111
2) Install suspension frame pads (1) to bushings (2) as
shown.
3) Install suspension frame and tighten suspension
frame bolts to specified torque.
Tightening torque
Suspension frame bolt (a): 90 N·m (9.0 kgf-m,
65.0 lb-ft)
2. Control rod No.1 (front side) 6. Differential mounting bracket 10. Stabilizer bar joint
3. Control rod No.2 (rear side) 7. Stabilizer bar F: Forward
4. Differential 8. Stabilizer bar mount bush : Tightening torque
1. Control rod
I2RH01230029-01
2
2
2
1
I2RH01230038-01
“c”: 54 mm (2.13 in.) or less “f”: 25 mm (0.98 in.)
“d”: 47 mm (1.85 in.) or more “g”: 46 mm (1.81 in.)
“e”: 38 mm (1.50 in.)
I2RH01230039-01
I2RH01230040-01