Suzuki Liana RH413, Руководство по обслуживанию

Страница: 572 / 1302

5A-24 Automatic Transmission/Transaxle:
DTC Clearance
S3RH0A5104007
As automatic transaxle DTC is stored in memory of ECM
and TCM respectively, be sure to clear it from both ECM
and TCM by using either method-1 and method-2 or
method-1 and method-3 of the following 3 methods.
NOTE
For vehicle without immobilizer lamp,
method-1 is not necessary to be performed,
because automatic transaxle DTC is not
stored in memory of ECM.
To Clear DTC Stored in ECM with Scan Tool –
Method-1
Refer to the same item in “DTC Clearance in Section 1A”
for reading procedure.
To Clear DTC Stored in TCM with Scan Tool –
Method-2
1) Turn ignition switch OFF.
2) After setting cartridge, connect SUZUKI scan tool to
data link connector (DLC) (1) located In underside of
instrument panel at driver’s seat side.
Special tool
(A): SUZUKI scan tool
3) Turn ignition switch ON.
4) Clear DTC according to instructions displayed on
SUZUKI scan tool. Refer to SUZUKI scan tool
operator’s manual for further details.
5) After completing the clearance, turn ignition switch
OFF and disconnect SUZUKI scan tool from data
link connector (DLC) (1).
To Clear DTC Stored in TCM without Scan Tool –
Method-3
1) Remove glove box (1) from instrument panel.
2) Turn ignition switch ON.
3) After 6 seconds or more, repeat connecting and
disconnecting diagnosis switch terminal (3) and
ground terminal (4) of blue monitor connector (2) 5
times at about 1 second interval within 10 seconds,
using service wire.
4) Check TCM that no malfunction DTC remains in
memory of it.
(A)
2
I3RH0A510010-01
3
4
2
1
1 2 3 4 5
I3RH0A510012-01