Suzuki Liana RH413, Руководство по обслуживанию

Страница: 583 / 1302

Automatic Transmission/Transaxle: 5A-35
Line Pressure Test
S3RH0A5104015
Purpose of this test is to check operating conditions of
each part by measuring fluid pressure in fluid pressure
line.
Line pressure test requires the following conditions.
• Automatic fluid is at normal operating temperature (70
– 80
°
C / 158 – 176
°
F).
• Fluid is replenished to proper level between FULL and
LOW on dipstick.
• Air conditioner switch is turned OFF.
1) Apply parking brake securely and place chocks
against wheels.
2) Remove right side engine under cover.
3) Remove fluid pressure check hole plug bolt.
4) Attach oil pressure gauge to fluid pressure check
hole in transaxle case.
Special tool
(A): 09925-37811-001
CAUTION
!
After attaching oil pressure gauge, check that
no fluid leakage exists.
5) Depress foot brake fully, run engine at idle and stall
then check fluid pressure in “D” or “R” range.
CAUTION
!
• Do not continue running engine at stall
speed longer than 5 seconds.
• After performing line pressure test, be sure
to leave engine running at idle for longer
than one minute before performing another
line pressure test.
Automatic transaxle line pressure
Troubleshooting
“D” range “R” range
At idle
speed 3.7 – 4.1 kg/cm 2 ,
53 – 58 psi
5.9 – 6.8 kg/cm 2 ,
84 – 97 psi
At stall
speed 12.5 – 13.7 kg/cm 2 ,
178 – 195 psi
16.5 – 19.0 kg/cm 2 ,
235 – 270 psi
(A)
I2RH0B510016-01
Condition Possible cause Correction / Reference Item
Higher than standard
level in each range Malfunction of pressure control solenoid
valve Inspect. If NG, replace valve body assembly.
Faulty valve body component Replace valve body assembly.
Lower than standard level
in each range Malfunction of pressure control solenoid
valve Inspect. If NG, replace valve body assembly.
Faulty valve body component Replace valve body assembly.
Clogged oil strainer Replace.
Faulty oil pump Inspect. If NG, replace.
Leakage from both “D” and “R” range
fluid pressure circuit Overhaul or replace valve body assembly.
Lower than standard level
only in “D” range Leakage from “D” range fluid pressure
circuit Overhaul or replace valve body assembly.
Lower than standard level
only in “R” range Leakage from “R” range fluid pressure
circuit Overhaul or replace valve body assembly.