Suzuki Liana RH413, Руководство по обслуживанию

Страница: 447 / 1302

Transfer: 3C-14
3) Press-fit pinion shaft front taper roller bearing by
using special tools and hydraulic press.
Special tool
(A): 09941–74910
(B): 09925–88210
4) Install bevel pinion shaft with new pinion shaft spacer
to transfer output retainer.
5) Drive in pinion shaft rear taper roller bearing by using
special tool and tapping lightly with plastic hammer
(1).
Special tool
(A): 09913–75810
6) Apply grease to new oil seal lip.
“A”: Grease 99000–25010
7) Drive in oil seal (1) by using special tool and
hammer.
Special tool
(A): 09913–75810
Transfer output flange oil seal installing depth
“a”: 1.0 – 2.0 mm (0.04 – 0.08 in.)
8) Install transfer output flange (1) by tapping with
plastic hammer and tighten transfer output flange nut
gradually so as rotational torque of bevel pinion shaft
to be in specified value.
NOTE
• If rotational torque of bevel pinion shaft
exceeds specification given in the
following, replace pinion shaft spacer and
tighten flange nut.
• Before taking measurement of rotational
torque, rotate pinion shaft over ten rounds
in advance.
Special tool
(A): 09930–40113
Tightening torque
Transfer output flange nut (reference): 90 – 150
N·m (9.0 – 15.0 kgf-m, 65.0 – 108 lb-ft)
Rotational torque of bevel pinion shaft (Bearing
preload): 0.5 – 1.50 N·m (0.05 – 0.15 kgf-m, 0.35
– 1.10 lb-ft)
1
(A)
(A)
(B)
(C)
(D)
1
I3RH01332024-01
(A)
(B)
I3RH01332025-01
1
(A)
I3RH01332026-01
2. Torque wrench
(A)
“a”
1,“A”
I3RH01332027-01
(A) 1
2
I3RH0A330007-01