Sony MVS-8000X SystemMVS-7000X System, Руководство пользователя

Страница: 507 / 706

USO
RESTRITO
Macro Operations in the Simple Type Flexi Pad Control Block
507
Ch
a
p
te
r 16
M
a
c
ro
s
To cancel the saving of a macro
To cancel the saving of a macro immediately after
performing it, hold down the [STORE STATS] button and
press the [UNDO] button.
Inserting a pause event
1
Press the [PAUS] button in the memory recall section.
The buttons in the memory recall section change as
follows.
Macro Operations in the
Simple Type Flexi Pad
Control Block
This section describes the macro operations carried out in
the simple type Flexi Pad control block.
Use the following buttons.
Numeric display
Memory recall
section
2
Enter the length of pause you want to set (0 to 999
frames).
3
Press the [PAUS ENTR] button.
This sets the pause length, and inserts the pause event.
The memory recall section display returns to its former
state.
Deleting a macro
1
In the Flexi Pad control block, press the [MCRO]
button.
This assigns the Flexi Pad control block to macro
operations.
The numeric display shows the previously selected
bank number and the number of the last recalled
register.
2
Select the bank of the register holding the macro you
want to delete.
For details of the method of operation, see step
2
(page 505) of “Recalling a Macro Register and
Executing a Macro.”
3
Hold down the [STORE STATS] button, and then
press the button in the memory recall section showing
the corresponding register number.
The button you pressed in the memory recall section
goes off, and this deletes the macro. The [STORE
STATS] button lights amber.
MCRO button
TAKE button
Status display
(Number of events executed/
total number of events)
To use the [MCRO] button
To enable the [MCRO] button for use as in the above
figure, it is necessary in the Setup menu to switch the
[UNDO] button to the [MCRO] button
(see page 572) .
Notes
In a simple type Flexi Pad control block, only registers 1 to
6 can be used for operations. There are no “bank”
operations.
For registers 7 to 250, use the numeric keypad control
block.
Recalling a Macro Register and
Executing a Macro
Executing a macro in normal execution
mode
1
In the simple type Flexi Pad control block, press the
[MCRO] button, turning it on.
This assigns the Flexi Pad control block to macro
operation.
The numeric display shows the number of the last
recalled register.
The buttons of the memory recall section show the
selected register status.
Lit orange: register holding macro data