Sony MVS-8000X SystemMVS-7000X System, Руководство пользователя

Страница: 116 / 706

USO
RESTRITO
116
Independent Key Transitions
Ch
a
p
te
r 3
S
ig
n
a
l S
e
le
c
ti
o
n
and
T
ra
n
s
itio
n
s
If, in the Setup menus, you set insertion and deletion
as independent modes, make the settings for the next
transition in the independent key transition control
block.
Separate settings are required both when inserting a
key and when deleting it. For example, with the key
not inserted, if you select the transition type and carry
out a transition, this will be the setting when inserting
a key.
You can also use the Transition menu to select a
desired independent key transition type for each key
(see the next section).
For details of the wipe settings, see “Wipe Settings for
Independent Key Transitions” (page 175). For details
of DME wipe settings, see “DME Wipe Settings for
Independent Key Transitions” (page 193).
3
Execute the transition.
To insert or delete the key gradually with a mix or
wipe transition: Press the [AUTO TRANS]
button.
For details of the transition rate, see “Setting the
Independent Key Transition Rate” (page 117).
For details of operation together with a common
transition, see “Combining other transitions with
independent key transitions” (page 113).
To cut the key in or out instantaneously: Press the
[KEY ON] button on the keyer.
Notes
•
In an independent key transition, the pattern limit
function is not available.
•
When the following DME effects are set, the effects
may be applied during wipe transitions. If the effects
are not necessary, cancel the settings.
-
Trail
- Motion Decay
- Wind
When the Keyframe Strobe effect is set, operating
keyframes do the same effect. Cancel the
unnecessary settings.
Independent key transition operations
when using the CCP-6224/6324 Control
Panel
Independent key transition execution section
Transition control block (compact type)
To carry out an independent key transition, press the
corresponding button in the independent key transition
execution section of the transition control block.
The color of the button shows the status as follows.
Lit green: transition in progress.
Lit amber: key inserted.
Lit red: key inserted into final program output.
Off: no key inserted.
For details of setting the transition rate, see “Setting the
transition rate in the Flexi Pad control block” (page 106).
Notes
The buttons for [Key5] to [Key8] and [DSK5] to [DSK8]
require previous assignment in the Setup menu
(see page
397) .
Setting the Independent Key
Transition Type by a Menu Operation
You can also select the required independent key transition
type by a menu operation.
1
In the M/E or PGM/PST menu, select first the desired
one from VF1 ‘Key1’ to VF4 ‘Key4,’ then HF6
‘Transition.’
The Transition menu for the selected appears.
2
Select the required transition type in the <Transition
Type> group.
If, in the Setup menus, you set insertion/deletion as
independent modes, make the settings for insertion in
the <On Transition Type> group, and the settings for
deletion in the <Off Transition Type> group.