Ross Synergy 2 SD, Руководство по установке

Страница: 65 / 414

Synergy Series Installation Guide (v18) Installation • 2–21
Installing Remote Aux Panels
Remote Aux panels are self-contained units that have their own power supply. Each panel controls the
switcher’s Aux Buses via a single control cable.
Even though an unlimited number of Aux panels can be connected to each of the
AUX PANEL
connectors, a practical limit of 16 Aux panels should be observed. This limit minimizes delay, and
allows 8 panels to be daisy-chained on each connector.
There are two types of remote Aux panels available:
• Assignable panels control all 12 Aux Bus outputs.
• Non-assignable (or “dedicated”) panels control a single Aux Bus output.
Both panel types require one rack unit of space for installation, and both types require their own
source of AC power as displayed in the following figure.
Aux Panel Rear Layout and Connection
Connector layout is identical for all remote Aux panels.
1. Power Port
One DC connector is provided for +5 VDC panel power.
2. GPI Port
One 9-pin “D” GPI connector is provided for special GPI triggers that allow a camera
operator to manually override the Aux panel selection. Refer to the section “
Remote
Aux Panel Cabling ” on page 3–3 for connection details. Refer to the section “ Aux Bus
Setup ” on page 9–3 for setup details.
3. Switcher Port
One 6-pin RJ-12 Telco connector is provided for connecting to the Aux connectors on
the rear of the control panel. Refer to the section “
Remote Aux Panel Cabling ” on
page 3–3 for connection details. For pinout information, refer to the section “ Pinouts ”
in Appendix A , “ Specifications ”.
1) Power Port
2) GPI Port 3) Switcher Port
4) Echo Port 5) AC Adapter
6) Cable Retainer
90 - 264 VAC Adapter
(p/n 103-012)
J5
MAIN
J1
ECHO
J4
POWER
J2
GPI
This class A device complies with Canadian ICES-003 and part 15 of the FCC Rules
Operation is subject to the following 2 conditions: (1) This device may not cause
harmfull interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
1 2 3 4
+5 V REG
1 A
AC
Source
DC
Connector
5
6
R