Ross Synergy 2 SD, Руководство по установке

Страница: 87 / 414

Synergy Series Installation Guide (v18) Installation • 2–43
5. Label the storage device and store it in a safe place.
It is recommended that you place the following information on the label:
• Synergy SD Switcher Model (2, 3, or 4)
• Software Option Codes Backup
• Today’s Date
• Synergy Software Version
This completes the procedure for saving your option codes to a storage device.
Recalling Option Codes
In case the option codes are accidentally erased or deleted, use the following procedure to recall
option codes:
1. Navigate to the Installed Options Menu 2-2 as follows:
• Press HOME B MORE B Setup B Installed Options B . MORE .
2. Insert the storage device containing the Software Option Codes backup that you
created in the section “ Storing Option Codes ” on page 2–42. You must wait 5 seconds
after inserting the USB key into the USB port before you can begin to recall your option
codes.
3. Press Recall Codes from Disk to recall all of your option codes.
4. Eject the storage device from the switcher.
This completes the procedure to recall option codes.
Caution
Do NOT remove the floppy disk or USB key from the switcher before
the LED on the floppy drive or USB port goes out. Doing so may
destroy the data on your floppy disk or USB key, as well as the data on
the next one you insert into the switcher.
Note
The Delete All SW Options function is reserved for factory use only.
Do not use this function.