Ross Synergy 2 SD, Руководство по установке

Страница: 219 / 414

Synergy Series Installation Guide (v18) Custom Control Basics • 8–43
4. Assign a New Name to the custom control as follows, or continue to the next step to
enter a Preset Name :
• Use the top
Horizontal
knob to move the cursor horizontally up or down a row to
select a letter.
• Use the middle
Vertical
knob to move the cursor vertically up or down a column to
select a letter.
• Press
Next Letter
to accept the currently selected letter and begin selection of the
next letter. If you make a mistake, you can use the
Prev Letter
button to go back
and adjust a letter.
• Press
Space
if you want to enter a space in the name.
• You can use a Standard PS/2 keyboard to perform the same actions as pressing or
rotating the
System Control
buttons and knobs. Refer to Chapter 2 “ Control
Panel Introduction ” of the Synergy Series Operation Guide for details.
5. Assign a Preset Name to the custom control as follows:
• Press Preset Names to display the Preset Names Menu .
Preset Names Menu
Note If the mnemonic option is purchased and installed, the Mnemonic
field displays the custom control name as it will appear in the
associated mnemonic display. Further mnemonic display
configurations are discussed in section “
Customizing Mnemonic
Displays — Banks ” on page 8–10.
Note As you rotate the Horizontal and Vertical knobs, note that on the
control panel’s buses, the pushbuttons that correspond to each
character (in sequence) light. If desired, you can press the MLE
pushbutton to select a character.
Important Do NOT place anything on your keyboard or place your keyboard in a
position where any of the keys could be accidently pressed. This could
result in the Switcher acting unpredictably.
Note If you start editing the name immediately, and then decide at some
point to choose a
preset name instead, all characters in the custom
name will be replaced by the preset name.