Ross Synergy 2 SD, Руководство по установке

Страница: 319 / 414

Synergy Series Installation Guide (v18) Still Stores • 11–3
Communications Connections
You can connect a number of Still Stores to your Synergy switcher. The procedure for connecting the
Still Store will depend on the type of Still Store you have. This section will provide general
instructions for connecting the Still Store to one of the Remote Ports on the back of the Synergy
Control Panel.
In order to properly complete this procedure you will need the following software options, cables, and
equipment:
• Still Store (Aprisa) Interface — This is the software option from Ross Video that
allows your Synergy switcher to control a Still Store.
• Interface Cable — This is a 9-Pin cable with a 9-Pin, D-Type (DB9) male connector on
one end, to connect to the remote port on the control panel, and a connector on the other
end to connect to your Still Store. Refer to the section “
Still Store Interface Cable
Pinouts ” on page 11–4 for information on the pin-outs and connector required for your
Still Store. Ross Video does not supply this cable.
Use the following procedure to connect a Still Store to your Synergy switcher:
1. Connect and secure the 9-Pin , Male , end of the Interface Cable to one of the Remote
Ports on the back of the Synergy control panel.
Synergy Series Control Panel — Rear View, Remote Control Ports
2. Connect and secure the other end of the cable to the appropriate port on the Still Store.
The suggested port for each supported Still Store is listed below:
• Chyron Aprisa 100 Stillstore — Connect the Interface cable to the RS-422 port or
the RS-232 port on the rear of the Aprisa 100 Still Store. Refer to the section
“
Chyron Aprisa 100 Still Store Cabling ” on page 11–4 for more information on
the cabling for this Still Store.
This completes the procedure for connecting a Still Store to the Synergy switcher. Refer to the section
“
Communications Setup ” on page 11–5 for instructions on how to set up communications protocols
on the Switcher, as well as on the Still Store.
Note
These instruction are provided as a guide, for specific information on
the Still Store you are connecting to the Synergy switcher, refer to the
documentation provided with your Still Store.
8 1 2 3 4 7 6 5 4 3 2 1
REMOTE TALLY
2 1 FRAME
AUX
Remote Ports