Ross Synergy 2 SD, Руководство по установке

Страница: 276 / 414

9–46 • Additional Installation Setups Synergy Series Installation Guide (v18)
DSK 1 (and DSK 2) Key Bus on Synergy 3 and 4 Switchers
The figure below illustrates the two Downstream Key Bus locations on the Synergy 2 switcher. Note
that sample crosspoint names are used.
DSK 1 and 2 Key Bus on Synergy 2 Switcher
Use the following procedure to program each crosspoint on the DSK’s Key Bus :
1. To program the key type, press and hold the Key Bus button that you want to program.
2. Press any one of the four key type buttons (
SELF KEY
,
AUTO SELECT
,
CHROMA
KEY
, and
PST PATT
) in any MLE keyer.
3. Release both buttons to complete the key type programming. The key type is now stored
in memory for the selected button.
4. To program the key source, press and hold the same Key Bus button that you pressed in
step 1.
5. Select the desired source on the Preset Bus in the Program/Preset MLE.
6. Release both buttons to complete the key source programming. The key source is now
stored in memory for the selected button.
Note
This procedure applies to all Synergy switchers.
DOWNSTREAM KEYER 1
ON N/S
CUT
AUTO
TRANS
SOURCE
1
SOURCE
2
SOURCE
3
SOURCE
4
SOURCE
5
SOURCE
6
SOURCE
7
DSK 3
SELECT
FLY
KEY
BORD SHDW OUTL
BORD
OFF
MATTE
FILL
KEY
MEM
KEY
INV
MASK
DSK 3
ON
Key Bus
DOWNSTREAM KEYERS
ON N/S
CUT
AUTO
TRANS
SOURCE
1
SOURCE
2
SOURCE
3
SOURCE
4
SOURCE
5
SOURCE
6
SOURCE
7
DSK 4
SELECT
DSK
1
DSK
2
MATTE
FILL
FLY
KEY
KEY
PV
ON
DSK 1
N/S
CUT
AUTO
TRANS
KEY
PV
KEY
MEM
BORD
KEY
INV
SHDW
MASK OUTL
BORD
OFF
SOURCE
1
SOURCE
2
SOURCE
3
SOURCE
4
SOURCE
5
SOURCE
6
SOURCE
7
DSK 3
SELECT
DSK 2
Key Bus
(DSK 2)
Key Bus
(DSK 1)