Ross Synergy 2 SD, Руководство по установке

Страница: 355 / 414

Synergy Series Installation Guide (v18) External DVEs • 13–9
5. Follow all procedures outlined in the section “ Communications Setup ” on page 13-11.
For each external DVE video and alpha input, these procedures allow you to perform the
following tasks:
• Name the BNC input
• Set up the BNC type (DVE video or alpha)
• Set up tallies
• Set up alphas (shaped or unshaped)
• Set up auto keys (associated alphas with primary video signals)
• Set up panel buttons
This completes the procedure to connect external DVE outputs.
Aux Bus Panel Programming
Each Aux panel (both local and remote) must be properly programmed to control the desired Aux Bus
outputs, and with the desired “rights” assigned.
Use the following procedure to program your Aux panels:
1. Ensure that each remote Aux panel is properly installed. Refer to the section “ Installing
Remote Aux Panels ” on page 2-21 for instructions.
2. Ensure that each remote Aux panel is properly cabled. Refer to the section “ Remote
Aux Panel Cabling ” on page 3-3 for instructions.
3. Ensure that your Auxiliary Output Worksheet is completed, as outlined in the section
“ Auxiliary Outputs ” on page 4-15.
4. Using the information from your Auxiliary Output Worksheet , follow all instructions
presented in the section “ Communications Setup ” on page 13-11. In this section, you
will program each local and remote panel, and assign specific switching parameters (or
“rights”) for each of the 12 Aux Buses that are accessible locally and remotely. Each
Aux Bus can be set up individually.
This completes the procedure to program your Aux panels.
GPI Input Connections
The Synergy switcher is able to use GPI input pulses from the DVE for Tallies. When an Aux Bus is
used to route video to a DVE, the
Tally Assignment procedure sets up the method for tallying that
bus. By selecting certain parameters, you can tally the bus (lighting the red “
ON
” LED on the Aux
panel) whenever the device is used on air — or as part of the composite on air image. Refer to the
section “ Setting Up Aux Bus Tallies ” on page 13-13 for complete instructions.
Note
This procedure applies to both primary and secondary external DVEs.
Note
This section applies to both primary and secondary external DVEs.