Ross Synergy 2 SD, Руководство по установке

Страница: 376 / 414

13–30 • External DVEs Synergy Series Installation Guide (v18)
Questech Charisma VTL
This section provides information that pertains to interfacing the Questech Charisma VTL to the
Synergy switcher — as the primary external DVE. Once the interface is set up, you can perform a
variety of Charisma-specific functions directly from the Synergy control panel — via RS-422 serial
control.
Available Charisma Functions
The following set of basic Charisma functions can be mapped to the custom control buttons on the
Synergy switcher:
Refer to the section “ External DVE Custom Controls ” on page 13–37 for custom control
instructions.
In addition, once communication is properly set up with the Charisma, the “ DVE Send ” feature is
operational. This feature allows you to perform fast and simple DVE transitions from the switcher
panel — as easy as selecting a Dissolve or a Wipe. When you set up a
DVE Send transition, you are
electronically routing a specific set of signals from the selected MLE to the Charisma for processing
— and then
back into the MLE for keying.
In the Synergy Series Operation Guide , refer to Chapter 11, “ DVE Send ” for complete instructions
on the DVE Send feature.
Charisma Serial Connection
This section describes the requirements for interfacing the Synergy switcher to the Questech Charisma
VTL.
Use the following procedure to connect the Synergy switcher to the Questech Charisma VTL DVE:
1. On the rear panel of the Charisma, locate the connector marked
EDIT CONTROL IN
,
as shown below:
Available Charisma Remote Control Functions
DVE Function Description
Go To Start Cues the Charisma to the start of its effect.
Go To End Cues the Charisma to the end of its effect.
Play Plays (runs) the Charisma effect forward.
Play Reverse Plays (runs) the Charisma effect in reverse.
Recall Recalls a selected Charisma effect (from 1 to 30 ).
Stop Stops the Charisma effect.
Pause Pauses (stops) the Charisma effect.