Ross Synergy 2 SD, Руководство по установке

Страница: 103 / 414

Synergy Series Installation Guide (v18) Preliminary Cabling and Check • 3–15
The default display in the Global Memory System Group indicates the following
information (for the DSK and the Program/Preset MLE):
~
REG:00
— Memory register 00 is preset
~
Memory0
— Memory register 00 was last recalled
~
M:015
— MLE (4, 3, or 2) transition rate is 15 frames
~
D:008
— DSK transition rate is 8 frames
~
F:20
— DSK fade-to-black transition rate is 20 frames
• In each MLE’s Key 1 and Key 2 group, the
AUTO SELECT
button is lit.
• In each switcher’s Downstream Keyer group, source 1 is selected.
• At the far right edge of each MLE’s Key Bus , the green
KEY 1
LED is lit. This
indicates that the Key 1 Bus is active.
• In the Positioner group, the
MLE 1
and
PATT
buttons are lit.
• In each switcher’s Mattes group, there is no default selection. Therefore the last
buttons selected will be lit.
• In the Pattern Control group, the
MLE 1
,
PP1
,
NORM
and
Vertical Wipe
(upper left wipe) buttons are lit.
• In the DVE Send group, the
MLE 1
button is lit.
4. Select sources for the transition:
• Ensure that
BLACK
is selected on the PGM Bus .
• Select
COLOR BKGD 1
on the PST (Preset) Bus .
~ Color Background 1 is factory preset to red.
~ Color Background 2 is factory preset to blue.
5. Ensure that
DISS
is selected in the PGM/PST MLE’s Transition group.
6. While watching the monitor, move the fader from one limit to the other, and verify that
the video dissolves from black to color.
7. In the MLE’s Transition group, press
WIPE
.
8. While watching the monitor, move the fader from one limit to the other, and verify that
the video wipes between color and black.
9. On the active bus, switch between two or three crosspoints (such as
COLOR BKGD 1
and
COLOR BKGD 2
) to ensure that “cuts” are taking place.
10. On the PGM Bus , press a re-entry crosspoint (
MLE 1
,
MLE 2
, or
MLE 3
, depending on
the switcher model).
11. On the selected re-entry bus, repeat steps 4 through 9. Instead of the PGM and PST bus,
use each MLE’s BKGD and PST buses.
12. Repeat steps 10 and 11 for each MLE in your system.
This completes the preliminary check. Once you are satisfied that video is switching and mixing,
continue with the remaining connection procedures.
Note When lit, the Up/Down arrows adjacent to the fader indicate which
direction to move the fader to complete the transition.