Ross Synergy 2 SD, Руководство по установке

Страница: 333 / 414

Synergy Series Installation Guide (v18) Editors/OverDrive • 12–7
Editor Communications Setup
This section will provide instructions for setting up the Editor to communicate with the Synergy
switcher. Refer to the section “
OverDrive Communications Connections ” on page 12–5 for
information on setting up communications between an OverDrive Standard System and a Synergy
switcher.
The following topic is discussed in this section:
• Setting up the Switcher
Setting up the Switcher
In order to have the Synergy switcher communicate with an Editor, the editor port on the frame that
the Editor is connected to must be set up to communicate with the particular Editor you have
connected.
Use the following procedure to configure the Editor port on the control panel to connect with a Editor:
1. Navigate to the Communications Menu 1-2 as follows:
• Press
HOME B MORE B Setup B Installation B Communications
.
2. Press
Type
to display the Communications Type Menu.
Communications — Type Menu
3. Activate the Editor Port as follows:
• Use the
Com Port
knob to select the Editor port,
EDITOR (ED)
.
• Use the
Device
knob to select
Editor
.
4. Press Editor Protocol to display the Editor Protocol Menu .
Communications — Editor Protocol Menu
5. Select the Editor Protocol as follows:
• Use the Com Port knob to select the Editor.