Ross Synergy 2 SD, Руководство по установке

Страница: 54 / 414

2–10 • Installation Synergy Series Installation Guide (v18)
• Note that an air filter is mounted on the back of the tray, behind the fans. This filter
should be cleaned periodically.
3. Frame CPU Board / Aux Bus Board
At the bottom of the chassis, the Frame CPU Board and Aux Bus Board connect
together, and are housed in the bottom slot.
• If the Timed Aux Bus option is installed in the field, the option’s Serializer
Module and De-serializer Module install on the Aux Bus Board .
4. MLE Carrier Board
This board houses up to four identical “daughter” boards — one for each MLE installed
in your system.
• Each MLE Board has positions for two additional option cards:
~ A 2D or 3D Squeeze & Tease card can be installed on the right side of the
MLE Board
~ A Dual Border Generator card can be installed on the left side of the MLE
Board
5. Re-entry Board
The Re-entry Board is a half-depth board that controls the switcher’s re-entry pathways.
6. Input Crosspoint Board Slots
Eight slots are provided for 8-input digital video crosspoint boards — for a maximum of
64 digital inputs. Each crosspoint board is
identical , and any crosspoint board can be
installed in any slot . Configuration of each input is performed through the menu system.
Warning When the power supply tray is inserted into the frame, it mates with
male power pins that carry
live voltage if the frame is plugged in. All
power must be disconnected before servicing
Caution Do not insert your fingers into the power supply slot when the unit is
plugged in!
Warning The Frame CPU Board (labeled Frame Processor Module
4000A-003 on the card front edge) must be installed only in slot 4 of
the Frame, as illustrated in the Synergy Series Frame, Front View
diagram above. Damage to Card and Frame will occur, otherwise.
Warning The MLE Carrier Board (labeled MLE Carrier 4000A-002 on the
card front edge) must be installed only in slot 5 of the frame, as
illustrated in the Synergy Series Frame Front View diagram above.
Damage to Card and Frame will occur, otherwise.
Note In the event of the failure of a Re-entry Board , an Input Crosspoint
Board can be used in place of the failed Re-entry Board in an
emergency.