Ross Synergy 2 SD, Руководство по установке

Страница: 71 / 414

Synergy Series Installation Guide (v18) Installation • 2–27
Control Panel Jumpers and Switches
For all switchers, the following figure illustrates the location of jumpers and switches on the front
edge of the
Control Panel CPU Board :
Control Panel Jumpers and Switches
1. Reset Button
Press the control panel’s red
RESET
button to initiate a full system reset. When the reset
is initiated from the control panel, the frame’s reset is initiated via a software message
that is passed along the RS-422 control cable. In the unlikely event that the frame has
crashed, it may be necessary to
manually reset the frame. Refer to the section “ System
Reset Notes ” on page 2–30 for additional important information about the system reset
function.
2. Configuration Switch 1
This switch is reserved for future use. Please leave the switch in the default
Off
position,
as labeled on the switch.
3. Configuration Switch 2
This switch is reserved for future use. Please leave the switch in the default
Off
position,
as labeled on the switch.
4. JP5, Panel Type
Jumper
JP5
works in conjunction with
JP6
to set the type of control panel. Refer to the
following table for details.
5. JP6, Panel Type
Jumper
JP6
works in conjunction with
JP5
to set the type of control panel. Refer to the
following table for details.
Setting the Control Panel by Jumper Type
1) Reset Button
2) Configuration Switch 1
3) Configuration Switch 2
4) JP5, Panel Type 5) JP6, Panel Type
6) JP7, Reserved
7) JP8, Reserved
8) JP9, Reserved 9) JP10, Reserved
10) JP11, Reserved
11) JP12, Panel Redundant Power
Jumper Synergy 2 Synergy 3 Synergy 4
JP5 Up Down Up
JP6 Down Up Up
Rear Connector Panel
Control Panel Front
Control Panel CPU Board
On
Off
JP5 JP6 JP7 JP8 JP9 JP10 JP11 JP12
1
RESET
2 3 4
5
6
7
8
9
10
11