Ross Synergy 2 SD, Руководство по установке

Страница: 301 / 414

Synergy Series Installation Guide (v18) Completing Setup • 10–9
• Press
Installation
to save Installation Registers to a storage device. The file
INSTALL.SYN is written to the storage device.
7. Eject the storage device from the Synergy switcher.
8. Label the storage device and store it in a safe place.
It is recommended that you place the following information on the label:
• Synergy Switcher Model (2, 3, or 4)
• Master Engineering Installation
• Today’s Date
• Synergy Software Version
This completes the procedure for saving your engineering setups to a storage device.
Caution Do NOT remove the floppy disk or USB key from the switcher before
the LED on the floppy drive or USB port goes out. Doing so may
destroy the data on your floppy disk or USB key, as well as the data on
the next one you insert into the switcher.
Note If you select a category that already contains a file (as indicated by the
File Icon ), the category will be overwritten.
Note Remember that you can use multiple storage devices for different
switcher setup configurations. Refer to the section “ Recalling
Configurations ” on page 10–10 for details on recalling files from
storage devices.