Ross Synergy 2 SD, Руководство по установке

Страница: 385 / 414

Synergy Series Installation Guide (v18) External DVEs • 13–39
• Use the
Effect
knob to select the effect you want to insert with the
Recall
command.
5. Press
Insert
to insert the selected command into the custom control and display the
Insert Special Menu 1-2 .
6. Insert additional commands if needed. When you have finished inserting commands,
proceed to the next step to complete the procedure.
7. Press
UP ONE
to display the Recording Menu .
8. Press
Finish Recording
, or the flashing custom control button, to finish recording the
selected custom control. The custom control button will stop flashing.
Once your custom control buttons have been programmed, be sure to properly name them. Refer to
the section “
Naming Custom Controls ” on page 8-42 for more information on naming custom
control buttons. Any recorded custom control can be edited.
To play back your macro, exit the Custom Controls Menu and press the custom control button on the
control panel that you recorded the custom control macro to.
Special Functions
Custom control buttons can be programmed to perform a variety of special functions for operational
convenience and efficiency. For external DVEs, these functions include:
• Reset GPI Custom Control
• Trigger GPI Custom Control
Reset GPI Custom Control
Use the following procedure to program a GPI reset custom control macro for your external DVE:
1. Navigate to the Custom Controls Menu as follows:
• Press HOME B Custom Controls .
Operating
Tip
DVE functions can be strung together (during the programming
mode), allowing one custom control button to perform
multiple
functions when it is pressed. For example, you can have the Recall
Effect 24 function followed by the Play function, allowing a single
custom control macro to recall an effect and then run it.
Note The bottom Effect knob only applies to the insert Recall command.
No value will be displayed for other commands.