Ross Synergy 2 SD, Руководство по установке

Страница: 80 / 414

2–36 • Installation Synergy Series Installation Guide (v18)
Software Versions
An error message occurs when the Squeeze & Tease 3D software is a different version than the
Synergy switcher software. This error message is displayed on the
Main Menu 1-2 , as seen in the
example below.
Main Menu — Software Version Message
If you receive this error message, you must verify the software versions of your Squeeze & Tease 3D
cards and your Synergy control panel. Contact Ross Video Technical Support if you have questions on
upgrading your Synergy switcher software version to match your Squeeze & Tease 3D cards.
Restoring Disk Registers
Use the following procedure to restore your disk registers to on-line memory:
1. Ensure that new Synergy software version is properly installed. If not, refer to the
section “ Software Upgrade ” on page 2–34.
2. Locate the “backup” storage device that you made in the section “ System Backup ” on
page 2–33.
3. Naivgate to the Disk Menu as follows:
• Press HOME B Disk .
4. Read the entire contents of the storage device into switcher memory as follows:
• Insert the backup storage device into its drive on the Synergy switcher.
• Press Recall to display the Disk Recall Menu .
• Press All to recall all categories of registers from the backup storage device.
5. Eject the storage device from the switcher.
This completes the procedure for restoring your disk registers.
Operating
Tip
You must wait 5 seconds after inserting the USB key into the USB port
before you can read its contents
Caution
Do NOT remove the floppy disk or USB key from the switcher before
the LED on the floppy drive or USB port goes out. Doing so may
destroy the data on your floppy disk or USB key, as well as the data on
the next one you insert into the switcher.