Ross Synergy 2 SD, Руководство по установке, Страница: 77 / 414

Synergy Series Installation Guide (v18) Installation • 2–33
System Backup
Use the following procedure to save your setup configurations to a storage device:
1. Navigate to the Disk Menu as follows:
• Press
HOME B Disk
.
2. Insert a storage device as follows:
• Insert a pre-formatted 1.44 MB high-density floppy disk into the floppy disk drive
of the Synergy switcher.
OR
• Insert a USB key into the USB port of the Synergy switcher. You must wait 5
seconds after inserting the USB key into the USB port before you can save setup
configurations to it.
3. Press
Store
to display the Disk Store Menu .
4. Press
All
to store all categories of registers to your storage device.
5. Eject the storage device from the switcher.
6. Label the storage device and store it in a safe place.
It is recommended that you place the following information on the label:
• Synergy SD Switcher Model (2, 3, or 4)
• Software Version [
vXX.xx
] Backup
• Today’s Date
This completes the procedure for saving your setups to a storage device. Please continue with the
“
Software Upgrade ” procedure.
Important Because the software upgrade process automatically returns the
switcher to default values, it is important that you back up all switcher
elements to a storage device, such as a floppy disk or USB key, at this
point.
Note If the floppy disk is not formatted (or if you wish to completely erase
all data from the disk), press
Format . Follow the instructions on the
display to format the floppy disk.
Caution Do NOT remove the floppy disk or USB key from the switcher before
the LED on the floppy drive or USB port goes out. Doing so may
destroy the data on your floppy disk or USB key, as well as the data on
the next one you insert into the switcher..