Ross Synergy 2 SD, Руководство по установке

Страница: 245 / 414

Synergy Series Installation Guide (v18) Additional Installation Setups • 9–15
Output Setup
The Output Setup Menu allows you to set up six specific output parameters:
• MLE Tally Setup
• MLE Aspect Ratio Setup
• Clean Feed Setup
• Fade to Black Setup
• Ancillary Data
• Trigger Field Setup
Each topic is discussed in the following sections.
MLE Tally Setup
The MLE Tally feature allows you to force a selected MLE to always function as if it is on air —
regardless of whether or not it is selected on the Program/Preset Bus .
Use the following procedure to set up a tally function for an MLE:
1. Navigate to the Output Menu as follows:
• Press
HOME B MORE B Setup B Installation B Output
.
2. Press
MLE Tally
to display the MLE Tally Menu .
MLE Tally Menu
3. Assign a tall function to a selected MLE as follows:
• Use the MLE knob to select the MLE for which you want to assign a tally function.
• Use the Tally knob to select the desired tally function. You can select between the
following:
~
Always — Select this option to tally the selected MLE regardless of what is
selected on the switcher’s Program/Preset Bus . The MLE’s red ON LED will
always be lit, and all sources selected on the MLE will tally accordingly. Use
this option for dual aspect ratio configurations as discussed previously.
~ On Air — Select this option when you want an MLE to be tallied only when it
is selected on the switcher’s Program/Preset Bus .
This completes the procedure to set up a tally function for an MLE.
Note
Once selected, the MLE tally settings remain in effect until changed.