Ross Synergy 2 SD, Руководство по установке, Страница: 246 / 414

9–16 • Additional Installation Setups Synergy Series Installation Guide (v18)
MLE Aspect Ratio Setup
The MLE Aspect Ratio Menu allows you to assign an output aspect ratio to a selected MLE. This
parameter is valid only when the Aspectizer option is installed. This feature is primarily designed for
the Synergy 2, 3, and 4 switchers, in which one MLE can be assigned as 4:3 and another MLE
assigned as 16:9 — for true dual aspect ratio production.
Use the following procedure to select the MLE aspect ratio:
1. Ensure that the Aspectizer option is properly installed. Refer to the section “ Dual
Aspectizer Option and Overview ” for information.
2. Navigate to the Output Menu as follows:
• Press
HOME B MORE B Setup B Installation B Output
.
3. Press
MLE Aspect Ratio
to display the MLE Aspect Ratio Menu .
MLE Aspect Ratio Menu
4. Select the MLE aspect ratio as follows:
• Use the MLE knob to select the MLE that you wish to assign an aspect ratio.
• Use the Aspect knob to select the desired aspect ratio.
This completes the procedure to select the MLE aspect ratio.
Clean Feed Setup
The Clean Feed From Menu allows you to set the point from which the clean feed signal is derived.
The selected signal is then routed to the
CLEAN
output connector on the rear of the frame.
Use the following procedure to set up the Clean Feed output:
1. Navigate to the Output Menu as follows:
• Press
HOME B MORE B Setup B Installation B Output
.
2. Press
Clean Feed From
to display the Clean Feed From Menu .
Output — Clean Feed From Menu