Ross Synergy 2 SD, Руководство по установке

Страница: 76 / 414

2–32 • Installation Synergy Series Installation Guide (v18)
Software Upgrade
This section provides step-by-step instructions for upgrading the Synergy switcher software from a
storage device. You can obtain a copy of the software, or of any previous version, by logging on to the
Ross Video website:
(http://www.rossvideo.com)
Use the following steps to perform a software upgrade from a storage device:
• Hardware Confirmation
• System Backup
• Software Upgrade
• Restoring Disk Registers
Hardware Confirmation
Use the following procedure to check the version of the CPU Board in your Synergy control panel:
1. Navigate to the Installed Options Menu as follows:
• Press
HOME B MORE B Setup B Installed Options
.
2. Press
Panel Boards
to display the Panel Boards Menu .
Installed Options — Panel Boards Menu
3. Locate the 4000-033 Panel CPU in the Board column.
4. Confirm that the Rev number is 10 or higher (in the example menu shown above the
CPU Board is a Revision 10a).
If your hardware meets the requirements of the software upgrade, proceed to with the next step and
backup your system.
Important If you are upgrading your Synergy switcher to a software version of
16 , or higher, you must ensure that your control panel CPU Board is of
Issue 10 or higher.
Important If the Panel CPU is of a Revision lower than 10 you will NOT be
able to upgrade to version 16 , or higher, without upgrading your
control panel.