Ross Synergy 2 SD, Руководство по установке

Страница: 236 / 414

9–6 • Additional Installation Setups Synergy Series Installation Guide (v18)
Assigning MLE Crosspoints to the Local Aux Panel
The Aux Bus Setup Menu allows you to set specific switching parameters (or “rights”) for each of
the 12 Aux Buses that are accessible from the control panel in the Aux Bus Assign Group . Each bus
can be set up individually.
• The Main Area of the Aux Bus Setup Menu provides a mini “help” message.
• The Label Area provides access to the additional setup menus.
• The Scroll Area provides three functions that are controlled by their respective knobs.
Use the following procedure to map MLE crosspoints to the local Aux Panel:
1. As required, refer to your Auxiliary Output Worksheet . Refer to the section
“ Connecting and Verifying Outputs ” on page 4–15 to verify the destinations and
functions of all Aux Bus outputs.
2. Navigate to the Aux Bus Setup Menu 1-2 as follows:
• Press
HOME B MORE B Setup B Installation B Aux Bus
.
3. Press
Local Panel
to display the Aux Bus Local Panel Setup Menu .
Aux Bus – Local Panel Setup Menu
4. Use the
Aux Bus
knob to select the Aux Bus that you want to configure. As you scroll,
each selected button lights in the Aux Bus Assign Group .
5. Use the
Mode
knob to select the mode for the selected local bus. You can choose
between the following:
•
OFF —
Use this option to turn the specific Aux Bus off — effectively disabling
access to the bus from the control panel . When the button in the Aux Bus Assign
Group is pressed, it lights momentarily — but it will not “take.” The bus can,
however, be controlled by a remote Aux panel.
• Regular — Use this option to place the specific Aux Bus in normal operating
mode. The bus can be selected and sources can be changed from the control panel.
Note that this mode also allows both
local and remote panels to control the Aux
Bus. This option is required when setting the Aux Bus as Definable .
•
Follow —
Use this option to place the specific Aux Bus in follow (or “view only”)
mode. You can select the bus in the Aux Bus Assign Group and follow what
crosspoints are being selected (remotely), but you cannot change crosspoints. In this
configuration, the bus is controlled from another location.
•
Bus Follow —
Use this option to place the specific Aux Bus in bus follow mode.
This mode directs the Aux Bus to follow the user’s selections on a specified MLE
and bus, and is only used in conjunction with the Dual Aspectizer hardware option.
Operating
Tip
You can also press a button in the Aux Bus Assign Group to select the
Aux Bus that you want to configure.