RKC INSTRUMENT COM-JG, Инструкция по эксплуатации

Страница: 26 / 126

5. SETTING
IMR01Y35-E3
20
3. When the power is turned on, controller address auto obtain starts.
While auto obtain is in progress, the RUN lamp of the COM-JG blinks.
The obtained addresses are stored in “Controller address” in the COM-JG initial setting items.
“Controller address” has 31 address spaces, Nos. 1 to 31 [equal to the maximum number of
controller (SRZ) connections], and the obtained addresses are stored in order from No. 1
beginning from the lowest-value address.
The COM-JG checks each controller (SRZ) address against addresses 1 to 99. For this
reason, a certain amount of time is required to complete auto obtain (up to about 90
seconds).
4. When controller address auto obtain is finished, the RUN lamp of the COM-JG stops blinking
and lights steadily.
5. Turn off the power and return DIP switch No. 4 on the left side of the COM-JG to OFF (auto
obtain OFF).
[Example] When the controller (SRZ) configuration is three Z-TIO modules and two Z-DIO modules
The data in controller addresses 6 to 31 will be “0” (No controller connected).
The controller address of a Z-TIO module will be the value (decimal) set in the address
setting switch plus “1.” The controller address of a Z-DIO module will be the value
(decimal) set in the address setting switch plus “17.”
COM-JG initial setting item
Automatically obtained
controller addresses
No. 1 Controller address 1
No. 2 Controller address 5
No. 3 Controller address 10
No. 4 Controller address 17
No. 5 Controller address 30
No. 6 Controller address 0
No. 31 Controller address 0
SRZ
Z-TIO
module
Z-DIO
module
1 5 10 17 30
Controller address
(Module address)
COM-JG
Obtained address
Addresses are stored in
order from No. 1 from the
lowest address.
In this example there are
five modules, and thus the
automatically obtained
addresses are stored in Nos.
1 to 5.