RKC INSTRUMENT COM-JG, Инструкция по эксплуатации

Страница: 108 / 126

8. USAGE EXAMPLE
IMR01Y35-E3
102
8.5.4 Communication item setting
Once the COM-JG initial settings have been completed, configure the communication item settings.
Communication item Attribute * Data type
Corresponding
module
Measured value (PV) RO Channel-based data
Set value (SV) R/W Channel-based data
RUN/STOP transfer R/W Module-based data
Z-TIO
Digital input (DI) state RO Module-based data
RUN/STOP transfer R/W Module-based data
Z-DIO
* RO: Read only, R/W: Read/Write
Refer to the setting procedure of page 72.
Data parameter setting
1. Double-click “COM-JG” registered to set each controller (SRZ) communicating item.
Refer to the figure of page 83.
2. Set the number of connecting channels (total number of continuous accesses) to “Number of
Channel of “Device-specific parameters.”
In this example, set is “11.”
Refer to Number of continuous accesses (P. 65) .
Sets “11”