RKC INSTRUMENT COM-JG, Инструкция по эксплуатации

Страница: 73 / 126

8. USAGE EXAMPLE
IMR01Y35-E3 67
Continued from the previous page.
Among the previously discussed communication items, there are three module-based items:
RUN/STOP
transfer
(Z-TIO), Digital input (DI) state (Z-DIO), and RUN/STOP
transfer
(Z-DIO). For
read and write of these items, disable the number of continuous accesses setting.
Continuous accesses enable/disable setting of Group 1 to 8
Group No.
Group 8
(Bit 7)
Group 7
(Bit 6)
Group 6
(Bit 5)
Group 5
(Bit 4)
Group 4
(Bit 3)
Group 3
(Bit 2)
Group 2
(Bit 1)
Group 1
(Bit 0)
Validate (1)/Invalidate (0) 0 0 1 0 0 0 1 1
A lower bit is Group 1.
The value of “Continuous access enable selection” of Groups 1 to 8 is 00100011
=
35
Groups 9 to 16, Groups 17 to 24, Groups 25 to 32, and Groups 33 to 40 do not use this setting, and
thus the factory set value of 255 (all enabled) should remain unchanged.
Group No. Group 1 to 8 Group 9 to 16 Group 17 to 24 Group 25 to 32 Group 33 to 40
Set value 35 255 255 255 255
Therefore, the continuous access enable selection setting is set as shown below.
“Continuous access enable selection” setting
COM-JG initial setting item Set value
Continuous access enable selection 1 to 8 35
Continuous access enable selection 9 to 16 255
Continuous access enable selection 17 to 24 255
Continuous access enable selection 25 to 32 255
Continuous access enable selection 33 to 40 255