Signal Generator Settings
R&S
®
SGT100A
161
User Manual 1176.8674.02 ─ 07
Bias
If a bias is enabled, a DC voltage is superimposed upon the envelope signal E and the
inverted envelope signal E BAR.
"I/Q Output Type"
"Bias" defines
Single Ended
-
The bias between the envelope signal E and ground
Differential
"To Ground"
Superimposed DC voltage = "Bias", where "Bias" is
related to the selected
.
See also
"Wire To Wire"
Superimposed DC voltage = "Bias", where "Bias" is
related to high impedance (1 M
Ω
).
Table 7-8: Effect of enabled bias
Effect of a positive bias
Effect of a negative bias
Use this parameter to define the operating point of a DUT.
Remote command:
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:ENVelope:BIAS
Offset
Sets an offset between the envelope and the inverted envelope signal.
The value range is dynamically adjusted.
The selected offset is set half in the positive and half in the negative direction.
Table 7-9: Effect of an enabled envelope offset
Effect of a positive envelope offset
Effect of a negative envelope offset
See also
Generation of Envelope Tracking Signals