![background image](http://html1.mh-extra.com/html/rands/nrpm/nrpm_user-manual_3219371051.webp)
Setting up a measurement
R&S
®
NRPM
51
User Manual 1425.8663.02 ─ 07
Connecting the R&S
NRPM3N to the controller PC with the PoE injector and
a non-PoE Ethernet switch
To connect the sensor module to the controller PC:
1. Connect the
of the sensor module to the PoE injector.
2. Connect the PoE injector to the AC supply (mains).
3. Connect the input of the PoE injector to the non-PoE Ethernet switch.
4. Connect the controller PC to the non-PoE Ethernet switch.
5. On the controller, establish a connection between the sensor module and the
Chapter 6.3.5, "Establishing a connection to the network"
Setup with a PoE injector
Required equipment
●
1 R&S
NRPM3N sensor module
●
2 RJ-45 Ethernet cables
●
1 PoE injector
●
Controller PC with LAN interface and installed VISA driver or R&S
NRP
Toolkit
and R&S
Power
Viewer
Mobile
Setup
Figure 6-9: Setup with a PoE injector
1
= Controller PC
2, 4 = RJ-45 Ethernet cable
3
= PoE injector
5
= LAN connector (RJ-45 Ethernet PoE interface)
6
= R&S
NRPM3N R&S
NRPM3N LAN sensor module
Connecting an R&S
NRPM OTA power measurement setup