![background image](http://html1.mh-extra.com/html/rands/nrpm/nrpm_user-manual_3219371151.webp)
Remote control commands
R&S
®
NRPM
151
User Manual 1425.8663.02 ─ 07
INITiate:CONTinuous
<state>
Activates the continuous measurement mode. In continuous measurement mode,
the sensor module does not change to idle state after a measurement cycle has
been completed, but enters the wait for trigger state. When a trigger event occurs,
it starts the next measurement cycle. This mode is also known as free-running
mode, although each measurement cycle depends on the trigger conditions.
Parameters:
<state>
ON
Measures continuously. If a measurement is completed,
the sensor module enters the wait for trigger state again.
OFF
Stops the continuous measurement mode. The sensor
module switches to idle state.
*RST:
OFF
Example:
Chapter 11.2, "Performing measurements in continu-
Manual operation:
10.10
Configuring the trigger
Further information:
●
Chapter 10.5, "Controlling the measurement"
Remote commands:
......................................................................................... 152
..................................................................................... 152
.............................................................................. 152
.................................................................................... 153
.......................................................................................... 154
TRIGger:EXTernal<2...2>:IMPedance
.....................................................................155
.............................................................................................156
Configuring the trigger