Remote control commands
R&S
®
NRPM
159
User Manual 1425.8663.02 ─ 07
TRIGger:SLOPe
<slope>
TRIGger:SOURce INTernal/EXTernal
Determines what is used for triggering, depending on the trigger source:
●
: uses the rising or falling edge of the envelope
power.
●
: uses the increasing voltage.
Parameters:
<slope>
POSitive | NEGative
*RST:
POSitive
Manual operation:
TRIGger:SOURce
<source>
Selects the source for the trigger event detector.
See
Parameters:
<source>
HOLD | IMMediate | INTernal | INT1 | INT2 | INT3 |
INTernal1 | INTernal2 | INTernal3 | BUS | EXTernal | EXT1 |
EXTernal1 | EXT2 | EXT3 | EXTernal2 | EXTernal3 |
BURSt1 | BURS1 | BURSt2 | BURS2 | BURSt3 | BURS3
BUS
Triggers the measurement with the commands
shortens the measurement. In this case, the other trigger
settings are meaningless.
EXTernal
Initiates the measurement by the hardware trigger bus, e.g
of the base unit. Waiting for a trigger event can be skipped
by
.
EXT
,
EXT1
,
EXTernal
and
EXTernal1
denote the same,
an external trigger is applied through the round 8 pin con-
nector.
EXT2
and
EXTernal2
refer to external triggering initiated
by the dedicated SMB type connector, TRIG2 I/O, at the
rear of the sensor module.
Configuring the trigger