![background image](http://html1.mh-extra.com/html/rands/nrpm/nrpm_user-manual_3219371052.webp)
Setting up a measurement
R&S
®
NRPM
52
User Manual 1425.8663.02 ─ 07
7
= Antenna connector
8
= Antenna module(s)
9
= AC power supply
Connecting the R&S
NRPM3N to the controller PC with the PoE injector
To connect the sensor module to the controller PC:
1. Connect the
of the sensor module to the PoE injector.
2. Connect the PoE injector to the AC supply (mains).
3. Connect the controlling host to the input of the PoE injector.
4. On the controller, establish a connection between the sensor module and the
network.
6.3.5
Establishing a connection to the network
There are two methods to establish a network connection:
●
The R&S
NRPM3N LAN sensor module and controlling host are connected to
a common network
(infrastructure network).
●
The R&S
NRPM3N LAN sensor module and controlling host are connected
only over the switch
(peer-to-peer network).
For both connections, the common network or the peer -to-peer connection over
the switch, you address the sensor module as follows:
●
Chapter 6.3.5.1, "Using hostnames"
●
Chapter 6.3.5.2, "Assigning the IP address"
Setting up an Ethernet connection
To set up a network Ethernet connection:
1. Connect the sensor module as described in
By default, the R&S
NRPM3N uses dynamic TCP/IP configuration (DHCP)
and obtains the address information automatically.
If both network status LEDs light up in green color, the connection of the
R&S
NRPM3N to the network is established successfully.
Note:
Establishing a connection can take up to 2 minutes.
Connecting an R&S
NRPM OTA power measurement setup