![background image](http://html1.mh-extra.com/html/rands/nrpm/nrpm_user-manual_3219371138.webp)
Remote control commands
R&S
®
NRPM
138
User Manual 1425.8663.02 ─ 07
MOVing
Returns each new average trace as a measurement result,
even if the FIR filter is not yet filled completely with mea-
sured traces.
This mode is suitable for measurements, where tendencies
in the result have to be recognized during the measure-
ment procedure.
REPeat
Returns a final trace result only after the FIR filter has
been filled with acquired traces.
This mode is suitable to avoid redundant results in mea-
surements.
*RST:
REPeat
Example:
TRACe:AVERage:TCONtrol REPeat
[SENSe<Sensor>:]TRACe:AVERage[:STATe]
<state>
Activates the averaging filter in trace mode.
Parameters:
<state>
*RST:
ON
[SENSe<Sensor>:]TRACe:DATA?
Returns the measured trace data in a pre-defined format. Unlike the
FETCh?
command, this command considers the settings of
on page 131 as explained below.
Command response
To describe the format of the command response, it is important to know some
additional information.
Besides the average power, the R&S
NRPM sensor module can measure addi-
tional measurands like "Minimum", "Maximum" or "Random". These additional
measurands are denoted as auxiliary measurands and can be selected with the
Configuring the measurement modes