![background image](http://html1.mh-extra.com/html/rands/nrpm/nrpm_user-manual_3219371161.webp)
Remote control commands
R&S
®
NRPM
161
User Manual 1425.8663.02 ─ 07
Make sure that the number of repetitions is the same for all the sensor modules
involved in the measurement. Otherwise, the trigger bus is blocked by any sensor
module that has completed its measurements before other sensor module and
has returned to the IDLE state.
Parameters:
<state>
*RST:
OFF
10.11
Using the status register
Further information:
●
Chapter A.2, "Status reporting system"
Contents:
General status register commands
............................................................... 161
Reading out the CONDition part
................................................................... 162
..........................................................................162
.......................................................................... 163
Controlling the negative transition part
..........................................................163
Controlling the positive transition part
........................................................... 164
10.11.1
General status register commands
Remote commands:
....................................................................................... 161
STATus:PRESet
Resets the edge detectors and
ENABle
parts of all registers to a defined value.
Usage:
Event
STATus:QUEue[:NEXT]?
Queries the most recent error queue entry and deletes it.
Using the status register