![background image](http://html1.mh-extra.com/html/rands/nrpm/nrpm_user-manual_3219371046.webp)
Setting up a measurement
R&S
®
NRPM
46
User Manual 1425.8663.02 ─ 07
Setup
Figure 6-5: Setup with an R&S
NRP-ZKU
1 = Controller PC
2 = R&S
NRP-ZKU
3 = USB host interface connector
4 = R&S
NRPM3 sensor module
5 = Antenna connector
6 = Antenna module(s)
Connecting a cable to the host interface of the R&S
NRPM3 sensor module
To connect the cable to the R&S
NRPM3 host interface:
1. Connect devices as shown in
:
a) Insert the screw-lock cable connector of the R&S
NRP-ZKU into the host
connector of the sensor module.
b) Tighten the union nut manually.
2. Establish the connection of the antenna modules as described in
ter 6.3.1, "Setting up the RF frontend"
Connecting the R&S
NRPM3 sensor module and the PC
1. Connect the R&S
NRP-ZKU USB connector to the controller PC.
2. On the computer, start a software application to execute the measurement,
Chapter 7, "Performing measurements"
Disconnecting the USB cable from the host interface of the R&S
NRPM3
To disconnect the R&S
NRP-ZKU cable from the sensor module:
1. Loosen the union nut of the screw-lock cable connector.
2. Remove the cable.
Connecting an R&S
NRPM OTA power measurement setup