R&S NRPM, Руководство пользователя

Страница: 157 / 235

Remote control commands
R&S
®
NRPM
157 User Manual 1425.8663.02 ─ 07
TRIGger:IMMediate
Triggers a generic trigger event that causes the sensor module to exit the
WAIT_FOR_TRIGGER state immediately, irrespective of the trigger source and
the trigger delay and start the measurement. The command is the only means of
starting a measurement when the trigger source is set to HOLD. Only one mea-
surement cycle is executed irrespective of the averaging factor.
Usage: Event
TRIGger:LEVel <level>
Sets the trigger threshold for internal triggering derived from the test signal.
This setting is effective only for the internal
TRIGger:SOURce
.
Parameters:
<level> Range: 1.0e-7 to 200.0e-3
*RST: 1.0e-3
Default unit: W
Manual operation: See "Trigger Level" on page 77
TRIGger:LEVel:UNIT <unit>
Sets the unit of the trigger level if this value is entered without a unit.
See
TRIGger:LEVel
.
Parameters:
<unit> DBM | W | DBUV
*RST:
W
Example: TRIGger:LEVel:UNIT W
Manual operation: See "Trigger Level" on page 77
TRIGger:SENDer:PORT <sender_port>
Selects the port where the R&S NRPM provides its internal trigger signal at the
output, provided it is trigger sender (see
TRIGger:SENDer:STATe
).
Configuring the trigger